Warning And Cautions; Kit Contents - CommScope MINI-OTE 300 Installation Manual

3 Warnings and cautions
Before installing and using the Mini-OTE 300, the user should fully understand the warnings and notes explained in this
section.
Do not disassemble the product
The user should not disassemble the product. If the user thinks a repair is necessary, contact the CommScope Technical
Support Team (800) 830-5056.
Installation site condition
For safe and stable use, the product should be installed in a site satisfying the following conditions:
• Install the product in a location where the fiber technician can easily access, connect and disconnect cables to the
product.
4

Kit contents

For safe and stable use, the product should be installed using the following components found in the Mini-OTE 300 kit.
Item
#
1 Mini-OTE 300 Terminal Enclosure
2 Cable retention hardware assembly (4)
Bolts for cable retention assembly 3/8" hex
3 head slotted (6)
4 Inline Ground Bar
5 Ground bar
6 Cable ties
Perforated foil (installer must cut in half, to be
7 used on all cables) (3)
8 Hand hole mounting clamp (2)
9 Hand hole clamp hardware – bolt 7/16 Hex (2)
Page 4 of 37
© 2021 CommScope, Inc. All Rights Reserved
Description
Item
#
10 Mini-OTE 300 port plugs (4), ground plug (1)
11 Mini-OTE 300 Ribbon standard grommet
12 Mini-OTE 300 LBT standard grommet
13 Mini-OTE 300 LBT micro grommet
14 Spiral Wrap 3/8", (2- 1ft.)
15 Routing Label
16 45 mm SMOUVS (30)
Pedestal mount optional hardware – SLTD Index
Hex Washer machine screw 10/24 x 1" (4) Nut
17 lock washer (4)
18 Spliceholder-FIST2-6S45
Description