Connection - Zepro Z 1500-135 Installation Instructions Manual

Connection

6.2 Connection
1. Release and fold out the control card / relay card.
2. Run the cabling through the grommet.
3. Connect the control devices concerned; see section 6.3 - 6.4. Connect angle sensor / inclinometer and
any warning lights; see section 7.
4. Run the cabling on the reverse of the control card / relay card and secure it with cable ties.
5. Fold in and secure the control card / relay card.
IMPORTANT!
Make sure no cables are pinched or in any other way damaged when the control card / relay card is
folded out/in.
Figure 60. Installing cabling with cable ties
6.2.1 After connection
1. When all cables are suitably located in the cable grommet, tighten the five screws; see Figure 59.
Tightening torque: 5 Nm.
2. Install the cable grommet's protective cover with the three supplied bolts, see Figure 57.
Tightening torque: 8 Nm.
Figure 61. Fasten the cable grommet's pro-
tective cover with three screws
38
Z/ZL 1500/2000-135/155/175
NOTE!
The illustration shows the ZePRO1
control card, but the operation is
the same regardless of the control
card / relay card model.
Figure 62. The cable grommet's five screws
www.zepro.com