Zepro Z 1500-135 Installation Instructions Manual page 24

Installation
4. Turn the adjuster sleeve until the platform fits
perfectly against the seal on the body. Figure 37.
5. Turn the adjuster sleeve until the platform fits
perfectly against the seal on the body. Figure 37.
6. Undo the three locking screws on the other tilt
cylinder. Figure 38.
7. Turn the adjuster sleeve until the tilt cylinder
aligns with the platform attachment point. See
Figure 38.
!
IMPORTANT
The max. length of both cylinders must be adjusted
equally to avoid unwanted bending forces.
8. Install the other tilt cylinder on the platform at-
tachment point. Use the shaft and support wheel
supplied.
!
IMPORTANT
Make sure the cylinder is installed with the grease
nipples facing up.
9. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
10. Adjust both cylinders alternately until the plat-
form touches the vehicle body; see Figure 37 (B).
11. Tighten the adjuster sleeve locking screws using
a torque wrench Tightening torque: 3-5 Nm.
24
Z/ZL 1500/2000-135/155/175
Figure 37. Adjusting the fit to the vehicle body
Out
In
Figure 38. Adjusting the tilt angle
Figure 39. Install the tilt cylinder on the platform
Locking screws, 3 pcs.
www.zepro.com