Zepro Z 1500-135 Installation Instructions Manual page 20

Installation
When installing on chassis with pre-drilled holes, pro-
ceed straight to Item 15.
body, see Figure 28
9. When mounting on frame without pre-drilled
holes, first install using a screw in the grooved
bracket holes. Mark the centre of the vehicle
frame in the grooved bracket holes, then drill Ø14
mm holes In the frame; see "6 Connection" on
page 37
10. Bolt the mountings securely on the exterior of
the vehicle frame. Use M14x45 bolts and install
the associated washer and nut on the inside of
the vehicle frame. Install the bolts but do not
tighten.
11. Check and fine trim the lift's position. Then
tighten the bolts with a torque wrench.
Tightening torque: 120 Nm.
12. Using a torque wrench, tighten the nuts holding
the U-profiles. Tightening torque: 280 Nm.
13. Drill holes in the vehicle frame for Ø14 mm at-
tachment bolts. Drill in the outer holes of each
mounting. Use M14x45 bolts and install the
associated washer and nut on the inside of the
vehicle frame. Installation must be performed
with at least 6 bolts in the outer holes. Do not
include the first screw installed in the grooved
hole. If necessary, it may now be moved to one
of the outer holes; see figure. Then tighten the
bolts with a torque wrench.
Tightening torque: 120 Nm.
14. Remove the mounting jig.
When installing on chassis with pre-drilled holes
15. Bolt the mountings securely on the exterior
of the vehicle frame. Install in the slot-shaped
20
Z/ZL 1500/2000-135/155/175
35 mm
Figure 28. The frame mount requires at
least 35 mm of space between the ve-
hicle chassis and the support frame
D
Min. 20
Min. 260
Min. 6 pcs.
M14x45 10.9
120 Nm
Figure 29. Install the chassis bracket
with at least six M14x45 10.9 bolts
New hole
www.zepro.com