Renishaw RLP40 Quick Start Manual page 6

In all applications involving the use of machine tools, eye
protection is recommended.
The RLP40 has a glass window. Handle with care if broken to
avoid injury.
Information to the machine supplier/installer
It is the machine supplier's responsibility to ensure that the user is
made aware of any hazards involved during operation, including
those mentioned in Renishaw product literature, and to ensure that
adequate guards and safety interlocks are provided.
Under certain circumstances, the probe signal may falsely indicate
a probe seated condition. Do not rely on probe signals to halt the
movement of the machine.
Information to the equipment installer
All Renishaw equipment is designed to comply with the relevant
EU and FCC regulatory requirements. It is the responsibility of
the equipment installer to ensure that the following guidelines are
adhered to, in order for the product to function in accordance with
these regulations:
• any interface MUST be installed in a position away from any
potential sources of electrical noise, i.e. power transformers,
servo drives etc;
• all 0 V/ground connections should be connected to the machine
"star point" (the "star point" is a single point return for all
equipment ground and screen cables) . This is very important
and failure to adhere to this can cause a potential difference
between grounds;
• all screens must be connected as outlined in the user
instructions;
• cables must not be routed alongside high current sources, i.e.
motor power supply cables etc, or be near high-speed data
lines;
• cable lengths should always be kept to a minimum.
Equipment operation
If this equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.