Renishaw RLP40 Quick Start Manual page 24

Changing the probe settings (when using with a RMI-Q)
Probe settings can be changed using Trigger Logic™.
3
Key to the symbols
LED short flash
LED long flash
Deflect the stylus for less than
4 seconds to move to the next menu
option.
Deflect the stylus for more than
4 seconds to move to the next menu.
To exit, leave the stylus untouched for
more than 120 seconds.
To exit, leave the stylus untouched for
more than 20 seconds.
CAUTION: Do not remove the batteries whilst in configuration
mode. To exit, leave the stylus untouched for more than 20
seconds.
24
2
> 5 s
1
LED check
Deflect the stylus and hold it deflected
until after the battery status has been
displayed at the end of the review
Battery status
Battery good
or
To partner the probe and/or change the
probe settings, go to the next page
sequence.
Battery low
.