Wireless Reset [Wre] - Canton Sound M Operating Instructions Manual

Manual (44 pages)

Table of Contents

English

Now select the speaker you want to pair and press "OK" to start the pairing process�

The Status indication should change to Pairing and the LED display indicates [PIR]�

Connect the (slave) speaker you want to pair to the mains and – if applicable – switch this speaker on at the power switch�

If the speaker is in stand by mode, turn it on by pressing the power button on the remote control�

Caution: The maximum time between pressing the OK button to start the pairing process and turning on the slave speaker is 30 seconds�

Approx� 10 – 20 seconds after switching on the slave speaker the displays should show [CON] resp� "Connected" at the OSD� From now on the display of the

(slave-)speaker and the display of the Sound M are in sync�

If "fail" appears in the OSD resp� [FAI] appears in the display, repeat steps 4 – 7 and make sure that...

a�) the desired slave speaker was disconnected from the mains for at least 30 seconds�

b�) not more than 30 seconds have been passed between pressing the OK button and witching on the slave speaker�

c�) the distance between the two speakers (soundbar and slave speaker) may not exceed 10 m and they are in the same room�

To pair a further speaker resp� a subwoofer, please repeat steps 4 – 7�

Caution: Should you have performed the above steps, never repeat them with the Sound M (master speaker) switched off, as this will automatically

designate a new master speaker and would prevent the previous slave speakers from connecting to the previously designated Sound M�

Note:

In connection with some Canton Smart products (for example like the Smart Connect 5�1) the Sound M can be used as pure wireless

Center-speaker� The Sound M will then be controlled by that particular Smart product� Please inform yourself about the required wireless

pairing process in the manual of that particular Canton Smart product�