Ir Learn [Irl] - Canton Sound M Operating Instructions Manual

English
Sleep Timer [SLP]
If this function is enabled, the Sound M shuts down into standby mode after a specified time� You can choose between 15 [15M], 30 [30M], 45 [45M]
or 60 [60M] Minutes� If the value [OFF] is selected, the function is disabled�
To adjust the shut down time, please follow the next steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button�
2
Select the menu Sleep Timer [SLP] and press the "OK" button to confirm�
3
Select the desired time using the "+" or "-" keys�
4
Press the "M" button to exit this menu item�
5
Note: The Sleep Timer will be disabled automatically after a power down� That means the shut down time must be selected after every
power up sequence�
IR Menu [IRM]
This menu includes all functions relevant for the infrared (IR) operation of the Sound M using a TV- resp� universal-remote�

IR Learn [IRL]

The Sound M can learn the infrared codes of another infrared-remote (TV- or universal remote control) and therefore allows you to control the
functions of the Sound M and another device resp� other devices with one remote control� You can allocate any key of the TV-/universal remote
control to your Sound M� When choosing a key, make sure that the commands for the Sound M are not in conflict with the other devices�
To learn the IR codes of a third party remote, hold the TV-/universal-remote control in position and do the following steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button�
2
Select the IR Menu [IRM] and press the "OK" button to confirm�
3
Choose the function IR Learn [IRL] and press the "OK" button to confirm�
4
[IRL] is flashing in the display� On the screen "Press the key you want to learn" is displayed�
5
Press the wanted function on the Canton Smart remote control e�g� "+" for Volume +�
6
Now the display shows the chosen function, e�g� "V+" or "Please press new button" and "Volume+" in the OSD�
7
Within 15 seconds, press the key you wish to allocate to this function on the TV-/universal-remote�
8
Once the IR command has been successfully allocated, the display shows [OK] resp� the OSD shows "Success" and you can continue with
9
the programming of the next function, e�g� "Volume –"�
22