Direct Input Learn [Dil] - Canton Sound M Operating Instructions Manual

If the display shows [FAI] the allocation has failed and you need to repeat steps 6 to 9� Please try a lower or higher distance between the Soundbar and
8
the TV-/universal-remote control in case the process fails again� Alternatively, try to press the key on the TV-/universal-remote shorter or longer�
To exit the IR Learn [IRL] menu, press and hold the "M" button for 3 seconds� After one minute without input, the system automatically
9
returns to the IR menu [IRM]�
Notes: • The red "On/Standby" key on the remote control has a dual function� Press it once and the display shows [ON] which allows the switching
on function to be programmed� If the red "On/Standby" key on the Canton remote control is pressed twice in quick sequence, the display
shows [STB] and the Standby resp� switching off function can be learned� If your TV-/universal-remote control has only one key for the "On" and
"Off" functions, both the "On" and "Standby" functions must still be allocated with this command�
• Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the Sound M�
• Signals from radio frequency (RF) remote controls cannot be learned, in general!

Direct Input Learn [DIL]

This function allows you a direct selection of the signal inputs if using a third party TV-/universal-remote control� In addition to the "serial"
selection of the inputs using the " " and " " keys on the Canton Smart-remote, you can directly select the signal inputs (e�g� ARC / [TV]) when
using your TV or universal remote control� That means you can allocate the desired input to a key on your remote control�
Learnable inputs: HDMI input 1–3 BDP / [HD1], SAT / [HD2] and PS / [HD3], HDMI
®
[COX], analog input AUX / [AUX] and Bluetooth
To learn the relating IR codes, hold the TV / third party remote control in position and do the following steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button�
2
Use the " " or " " button to select the IR Menu [IRM] and press the "OK" button to confirm�
3
Use the " " or " " button to choose the function Direct Input Learn [DIL] and press the "OK" button to confirm�
4
The OSD shows "Press the new button" and [HD1] is flashing on the display and "BDP" is displayed on the screen for the first HDMI input� You can now
5
assign the BDP / [HD1] input to a button on your TV-/universal-remote control�
Note: If you press this key on the remote control while the Sound M is in normal mode, the Sound M switches directly to the input [BDP],
independent of the current input�
Press the desired key on the TV-/universal-remote control� If the infrared code has been successfully stored by the system, [OK] is shown briefly in the
6
display resp� "Success" on the screen, followed by the next input SAT [HD2]�
input BT / [BT]
®
output TV / [ARC], optical input CD / [OPT], coxial input DVD /
®
English
3 2 3