Canton Sound M Operating Instructions Manual page 26

English
If ECO is selected, all wirelessly connected speakers will be powered down automatically, but each speaker must be powered up individually� This is the
operation mode with the lowest standby power consumption� All the other modes Network, Auto, and Manual provide an automatic power up function for all
wirelessly connected speakers when powering up the Sound M (Master Device)� You can find additional information in the description in the "Sub Output" and
"Wireless Speaker Pairing" part�
Notes: • If the standby mode is set to Auto [AUT] and the Soundbar is set to standby mode using the "ON/Standby" key of the remote control, it is not possible
for the Soundbar to switch on automatically� To use the Auto mode of the Soundbar as intended, do not power down the Soundbar using the
On/Standby key but always wait until the Soundbar powers down, automatically�
• To avoid an unintentional power-up of the Soundbar using the analog input (e�g� by humm), the threshold value has been set quite high� To make sure
the
Sound M powers up correctly, please set the output level of your analog audio source to a high level (but not more than 2Vrms)�
To set the standby mode, please do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button�
2
Choose the function Standby Mode [STB] using the
3
Use the "+" or "-" button to select the wanted Standby mode and confirm with the "OK" button�
4
Press the "M" button to exit this menu item�
5
Input Config [INP]
With the default factory setting all physically available inputs are already assigned with a source designation� Therefore, the device display and the
screen do not show the designation of the (physical) input, but the designation of a (possible) source device (e�g� [BDP])� These are as follows:
Physical input
HDMI Input 1
®
HDMI Input 2
®
HDMI Input 3
®
HDMI Output
®
Optical digital input
Coax digital input
Analog line input L/R
26
" " or " " button and confirm with the "OK" button.
OSD Display Name
HDMI1 [HD1] = BDP
HDMI2 [HD2] = SAT
HDMI3 [HD3] = PS
ARC [ARC] = TV
OPT [OPT] = CD
COAX [COA] = DVD
Analog [LIN] = AUX
(Blu-ray player)
(Satelite receiver)
(Gaming console)
(TV)
(CD player)
(DVD player)
(Analog device)