End Of Life; Removing The Product From Use; Recycling And Waste Disposal - Halton Rex Expander Installation And Maintenance Manual

Table of Contents

Halton Rex Expander (RXP) - Installation, commissioning, and maintenance guide

7 End of life

1. Disconnect the wiring.

2. Disconnect the duct connection.

3. Disconnect the water connections.

4. Dismount the unit.

Carry out all recycling and waste disposal in accordance with the law and regulations of each country. Observe the

specific requirements enforced by the legislation and local authorities of each country. Keep the environment clean.

Packaging waste

Packaging materials that can be recycled are listed below. They must be disposed of in conformity with existing

local regulations.

▪ Polyethylene: outer protective film

▪ Cardboard: angle protections, cardboard boxes etc.

▪ Wood: pallet, plywood etc.

Electronic and other components

Any electronic and other corresponding components of the product should be assessed for the most suitable

recycling route in accordance with local regulations.

Recycling after decommissioning

Recycle the product and its components upon decommissioning. Follow the local laws and regulations when

disposing of electrical components and steel materials. The following instructions are general.

▪ Disconnect and dismount all electrical and/or pneumatic components (such as actuator, junction box,

switches, cables etc.).

▪ Recycle electronic and other corresponding components of the product in accordance with WEEE provisions.

1.0

NOTICE

All installation, commissioning, and maintenance work must only be carried out by

qualified personnel.

NOTICE

All electrical work must only be carried out by qualified personnel.

NOTICE

Table of Contents

Do you have a question about the Rex Expander and is the answer not in the manual?