ABB 7320 Series Instruction Manual page 27

Set Up
Outputs
Factory Settings
Factory Set Code
0000
S = 4000 R = 4000
(PEAK) S = 60 R = 60
Ref. Total Low
xxxx
Sig. Total Low
xxxx
Ref. Total High
xxxx
Sig. Total High
xxxx
Ref. Peak Low
xxxx
Sig. Peak Low
xxxx
Ref. Peak High
xxxx
Sig. Peak High
xxxx
Reference Factor
1.000
Cal. Span Value
40.00 mg/l
Factory Settings
These parameters are set at the factory and will not need further adjustment
on site. Access must only be undertaken by nominated personnel.
Diss. Organics
page
Secure Factory Settings Access
Enter the required security code (between 0000 and 9999). Access will be
denied if an incorrect value is entered.
Displays the raw signals from the sensor.
S = UV254 Signal, R = IR880 Reference Signal.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This value is updated after a sensor calibration and is for diagnosic purposes
only.
This setting does not need to be adjusted.
This setting does not need to be adjusted.
Continued...
6 MAINTENANCE...
25