Emerson EV2000 Series User Manual page 105

Para. Name
Parameter displayed at
F8.03
STOP state
Coefficient of displayed
F8.04
speed
Coefficient of displayed line
F8.05
speed
Coefficient of displayed
F8.06 analog close loop
parameter/ feedback
Group F8: Display Parameters
LCD Display
Binary settings:
0:No display;
Unit's place of LED:
Bit0: Reference frequency(Hz)
Bit1: External counting value(no unit)
Bit2: Spinning speed(R/MIN)
Bit3: Reference speed(R/MIN)
STOP DISPLAY
Ten's place of LED:
Bit0: Line speed(M/S)
(flashes, ▲ and
Bit1: Reference line speed(M/S)
▼ key are valid
Bit2: VCI(V)
in frequency
Bit3: CCI(V)
displaying status;
Hundred's place of LED:
the status will be
Bit0: Analog close loop feedback(%)
saved at power
Bit1:Analog close loop setup(%)
off)
Bit2: Actual length
Bit3: Reference length
Thousand's place of LED:
Bit0: Terminal status(no unit)
Bit1: Bus voltage
Note: The reference frequency will be displayed in
default if all the Bits are 0
0.1~999.9%
Spinning speed = actual spinning speed*F8.04(PG)
Spinning speed=
120*operating Frequency/FH.00*F8.04(non PG)
SPEED
Reference speed =
FACTOR
close loop reference speed*F8.04(PG)
Reference speed=
120*reference frequency/FH.00*F8.04(non PG))
Note: No influence to actual speed
0.1~999.9%
Line speed = running frequency*F8.05(non PG))
Line speed = spinning speed*F8.05(PG)
LINE SPEED
Reference line speed = reference frequency*F8.05(non
FACTOR
PG))
Reference line speed=reference speed*F8.05(PG)
Note: No influence to actual speed
CLOSELOOP 0.1~999.9%
DISPLAY Note: Analog close loop reference/feedback displaying
FACTOR range:0~999.9
EV2000 Series Universal Variable Speed Drive User Manual
Setting Range
1:Display
Appendix 1 Parameters
Factory
Unit
Setting
1 1FF
0.1% 100.0%
0.1% 1.0%
0.1% 100.0%
101
Modif.
○
○
○
○