Safety Notes - JTS E-7HHSETD/ 5 Instruction Manual

UHF Audio Transmission System
These instructions are intended for users with-
out any specific technical knowledge Please
read the instructions carefully prior to operation
and keep them for later reference All control
elements described can be found in the figures
on pages 2 and 3
1 Overview
1.1 Receiver
1-channel receiver E-7R
A
for E-7BPSET/ 5 and E-7HHSET/ 5
2-channel receiver E-7Du
B
with two identical receiver units
for E-7BPSETD / 5 and E-7HHSETD / 5
1 On /off switch POWER
2 Display to indicate the channel
3 Button to set the channel
4 Reception LED(s)
(red) = radio reception
A
(green) = audio transmission
LED red = radio reception
B
LED green = audio transmission
5
Volume control
A
Volume control buttons
B
6 Receiving antennas
7 Power supply jack to connect the power
supply unit provided
8 Switch to set the level for the audio output
9 Audio output (6 3 mm jack, balanced) for
connection to an audio input of the follow-
ing device
10 Strain relief for the cable of the power
supply unit
1.2 Wireless hand-held microphone
for E-7HHSET/ 5 and E-7HHSETD / 5
11 Button to set the channel
12 Battery compartment
13 Power LED
green = batteries sufficiently charged
red = batteries almost discharged
LED flashing = device muted
14 Display to indicate the channel
15 Button POWER / MUTE
– to switch on: press the button briefly
– to mute / unmute: press the button briefly
– to switch off: keep the button pressed
16 Screw sleeve; after unscrewing the sleeve,
the button (11) for setting the channel and
the battery compartment (12) are accessible
1.3 Pocket transmitter
for E-7BPSET/ 5 and E-7BPSETD / 5
17 Button POWER / MUTE
– to switch on: press the button briefly
– to mute / unmute: press the button briefly
– to switch off: keep the button pressed
LED of the button is used as a power LED:
green = batteries sufficiently charged
red = batteries almost discharged
LED flashing = device muted
18 Connection (mini-XLR, 4-pole) for the lava-
lier microphone provided
19 Display to indicate the channel
20 Button to set the channel
21 Clip to attach the transmitter to your clothes
(e g belt)
22 Battery compartment cover

2 Safety Notes

The product corresponds to all relevant directives
of the EU and is therefore marked with
WARNING
The power supply unit of the
receiver uses dangerous mains
voltage Leave servicing to
skilled personnel only Inexpert
handling may result in electric
shock
•
The product is suitable for indoor use only
Protect it against dripping water, splash water
and high air humidity The admissible ambient
temperature range is 0 – 40 °C
•
Do not use the product and immediately
disconnect the power supply unit from the
socket
1 if the receiver or the power supply unit is
visibly damaged,
9