Download  Print this page

JTS SIEM-111T Manual

Pll stereo/mono in ear monitoring system
Hide thumbs

Advertisement

Advertisement

Table of Contents
loading

  Also See for JTS SIEM-111T

  Related Manuals for JTS SIEM-111T

  Summary of Contents for JTS SIEM-111T

  • Page 2 ATTENTION Please pay high attention to the following information. Sound Level (dB) Duration per day (hrs) The guideline published by Occupational Safety Health Administration (OSHA) in United States indicates overload volume level for prolonged listening may harm your hearing. Here below are referenced data on maximum time exposure to sound level before hearing injury occurs.
  • Page 3: Table Of Contents

    4-1 SIEM-111T 4-2 SIEM-111R 8. Recommendations 4-3 Optional Accessory Thank you for choosing the JTS in ear monitoring system. In order to obtain the best efficiency fromthe system, you are recommended to take few minutes to read this instruction manual carefully.
  • Page 4: Important Cautions

    Important Cautions .Full LCD display with backlight on both SIEM-111T .Make all connections before plugging the unit into an and SIEM-111R. AC power outlet. .Do not leave the devices in a place with high .Lock-on mode on both SIEM-111T and SIEM-111R.
  • Page 5: Specification

    5. Switching power supply: 100-240 V 4 Set Switch 6. Two pcs of AA battery with life over 12 hours 5 “ - ” Switch 7. Net weight: SIEM-111T: 1.45kg 6 Volume Control SIEM-111R: 0.2kg 7 Monitor Volume Control 8 1/8” Stereo Phone Jack 9 1/4”...
  • Page 6: Siem-111R

    4-2 SIEM-111R Rear Panel 1 AC Power Socket and Fuse 1 Antenna 2 Balanced Loop Out Connector CH.1 2 Power Switch and Volume Control 3 Balanced Loop Out Connector CH.2 3 Balance Control 4 Balanced XLR/φ6.3mm Combo Input Left / CH.1 4 1/8”...
  • Page 7: Preparing Procedures

    4-3 Accessory Preparing Procedures 1. IE-1 1 Earphone 5-1 SIEM-111T 2 Silicon Sleeve 1. Set the rubber pad 3 Cord Four self-adhesive rubber pads are provided to ensure the 4 1/8” Stereo Phone Plug stability. They are to be placed on the bottom of the 5 Case transmitter.
  • Page 8: Siem-111R

    (Figure 1) Connect the mixer output to the XLR /φ6.3mm combo (3) Upright the battery tray.(Figure 2) input in the rear panel of SIEM-111T with the AF input (4) Push down and slide the lid of the battery tray cable.
  • Page 9: Optional Accessory

    5-3 Optional Accessory 2. Connect with the earphone IE-1 (1) Plug the earphone into the jack of the receiver. 1. DR-900/RP-900 Rack Mount Kit (Figure 1) Rack mount kit is available to install the half rack (2) Make sure the volume is at low level to avoid injury transmitter into a standard EIA rack.

This manual is also suitable for:

Siem-111r