Canon W7200 User Manual page 42

Note
2-16
Print Media You Can Use
z While roll media is loaded in the printer, avoid opening and closing the roll media
tray. Opening and closing the tray causes the printer to cut the leading edge of the
roll media and consume paper.
z You should remove each sheet output to the output stacker, one at a time.
z Before the printer is shipped from the factory, the Roll Media Type is set for Plain
Paper.
z It is recommended that the special settings (1 to 5) be used when smudges and
blots appear on the print density is too light while printing on one of the media
types listed above. The Special settings determine in 5 steps the amount of ink used
on the surface of the media. The higher the number in the range of 1 to 5, the
greater the amount of ink used. The setting may require testing and adjustment,
depending on the media in use and the content of the image.
z The media size is detected automatically, therefore no setting for the size is
required.
z In order to align the leading edge correctly on the W7200, the paper is fed
approximately 100 mm (4 in.) then cut. On the W7250 without the stand installed,
the paper is feed 300 mm (11.8 in.) then cut.
z When the optional stand is not installed with the W7250, pressing
media only about 130 mm (5.1 in.) to ensure that the surface of the printing area is
clean.
feeds the roll