Canon W7200 User Manual page 140

No Printhead
Problem 1: The printhead is not installed.
Solution:
Check Printhead
Problem 1: The printhead is not installed.
Solution:
Problem 2: The printhead installed cannot be used with this printer.
Solution:
Memory Overflow
Problem 1: Print job cannot be processed due to the large amount of data.
Solution:
Solution:
No Media
Problem 1: The media in the selected source has run out.
Solution:
Media Too Large
Problem 1: The loaded media is larger than any media size allowed for loading in the
Solution:
Media Skewed
Problem 1: The loaded media is skewed.
Solution:
Solution:
7-16
Troubleshooting
Install the printhead correctly. (Æ P.6-18)
Install the printhead correctly. (Æ P.6-18)
Install the printhead for this printer. (Æ P.6-18)
Check and lower the resolution and quality settings in the printer driver.
Use the banner printing feature to divide the job.
Load the media then press the Online button. (Æ P.2-7, P.2-18)
printer.
Set the correct size media then try again. (Æ P.2-7, P.2-18)
If roll media is in use, open the upper cover, raise the paper release lever,
open the roll media tray, take-up some of the media manually to correct the
skew then try again. (Æ P.2-7)
If a cut sheet is in use, open the upper cover, raise the paper release lever,
remove the cut sheet, set it again then retry. (Æ P.2-18)