Turning The Unit On; Starting Up The Navigation; Receiving Gps Signals - Sony nav-u NV-U50 Quick Start Manual

Turning the unit on

Check that the POWER switch on the bottom
right of the unit is in the ON position
beforehand (page 7).
1
Press ?/1.
To turn the unit off
Press ?/1.
The unit enters standby mode for minimum
power consumption.
Note
Be sure to take the unit out of the cradle and
disconnect the car battery adapter when the unit is not
in use to prevent car battery drain.

Starting up the navigation

1
After turning the unit on, touch the
desired language.
The warning display appears.
2
Read the warning display, then touch
"Agree."
The tutorial displays appear.
3
Touch V to proceed.
The top menu appears.

Receiving GPS signals

After the initial installation, park your car in a
safe, open place (no high buildings, etc.) for up
to 20 minutes to allow for GPS signals to be
received before using the navigation system. The
system requires signals from a minimum of 3
GPS satellites to calculate the current car
position properly.
You can check the GPS status on displays.
* Lights up in bright green when signal reception is
sufficient for navigation.
Lights up in dark green when signal has been lost.
GPS status indicator*
11