Turning The Unit On; Performing Initial Setup - Sony NAV-U NV-U81T Quick Start Manual

C:\WINNT\Profiles\Administrator\Desktop\NAV-
U\2695873121NVU81U\01US02NAV-U.fm
00US+00COV-U.book Page 10 Friday, November 10, 2006 6:24 PM

Turning the unit on

The unit's built-in battery is not
charged at the time of purchase.
When there is no battery power,
connect the AC power adapter or the
car battery adapter to charge the
battery or to operate the navigation
system (the system can be operated
while the battery is being charged).
Press ?/1 (4).
The display appears as follows.
During route guidance, the map display
appears.
In other cases, the top menu appears.
To turn the unit off
Press ?/1 (4).
The unit enters standby mode for
minimum power consumption.
Note
Be sure to take the unit out of the cradle and
disconnect the car battery adapter when the
unit is not in use to prevent car battery drain.
10

Performing initial setup

The following contents can be set up by
the Startup Configuration Wizard.
– Language
– Distance format
– Brightness
– Time format
– Address input method
– Home address
– Home phone number (BLUETOOTH
models only, such as the NV-U81)
Follow the on-screen instructions to
perform the setup.
These settings can then be further
configured in the setting menu at any
time (page 20).
Note
The current time setting (including time
zone of current region and daylight saving
time/standard time) is automatically set after
GPS signals are received correctly.
NV-U81T/U81
2-695-873-12 (1)
masterpage:Right