Turning The Unit On; Performing Initial Setup - Sony NAV-U NV-U81T Quick Start Manual

Turning the unit on

Check that the POWER switch on the
bottom left of the unit is in the ON
position beforehand (page 8).
Press ?/1 (4).
The display appears as follows.
During route guidance, the map display
appears.
In other cases, the top menu appears.
To turn the unit off
Press ?/1 (4).
The unit enters standby mode for
minimum power consumption.
Notes
• Do not turn the main power off except
when the unit will not be used for more
than 3 months.
• If you switch off the main power, it may
take time to receive GPS signals when
switching on again.
• Be sure to take the unit out of the cradle
and disconnect the car battery adapter
when the unit is not in use to prevent car
battery drain.

Performing initial setup

The following contents can be set up by
the Startup Configuration Wizard.
– Language
– Distance format
– Brightness
– Time format
– Address input method
– Home address
– Home phone number (BLUETOOTH
models only, such as the NV-U80)
Follow the on-screen instructions to
perform the setup.
These settings can then be further
configured in the setting menu at any
time (page 18).
Note
The current time setting (including time
zone of current region and daylight saving
time/standard time) is automatically set after
GPS signals are received correctly.
9