Marking Track Numbers - Sony DHC-MD373 Operating Instructions Manual

Marking track numbers

You can mark track numbers:
• Automatically during recording
Track numbers are automatically marked as on the
original source during recording from this
system's CD player or components connected to
the DIGITAL OPTICAL IN jack. Use the Level
Synchro Recording function to automatically mark
track numbers during recording from this system's
tuner or components connected to the LINE IN
jack or the TAPE IN jacks. However, you cannot
mark track numbers automatically if the sound
source to be recorded is noisy (e.g., tapes or radio
programmes) or during timer-recording.
• At any point during recording
You can mark track numbers during recording any
sources.
• After recording
Use the Divide Function (see page 41).
Marking track numbers
automatically during
recording
The Level Synchro Recording function is factory
set to on, so the track numbers are automatically
marked. If "LEVEL-SYNC" does not appear
during recording, turn on the Level Synchro
Recording as follows. Track numbers are
automatically marked when the input signal is
continuously below a certain level for more than
two seconds and then exceeds that level.
Note
You can not mark track numbers automatically if the
sound source to be recorded is noisy (e.g,. tapes or
radio programmes).
30
— Level-Synchro Recording
`/1
3,6
m
4,5
.
H
1
Press FUNCTION repeatedly until
"TUNER" appears.
To record from other components connected
to this system, select "TAPE" or "LINE IN".
2
Press z REC to stand by for recording.
3
Press MENU/NO on the remote.
"Setup ?" appears, then press ENTER/YES
on the remote.
4
Press . or > on the remote
repeatedly until "T.Mark Off" appears,
then press ENTER/YES.
5
Press . or > repeatedly until
"T.Mark LSync" appears, then press
ENTER/YES.
"LEVEL-SYNC" lights up.
7
Z HS x
Z HS x
z
. m M >
2 1
`/1
3,4,5
M
4,5
>