Marking Track Numbers - Sony CMT-F3MD Operating Instructions Manual

Marking track numbers

You can mark track numbers:
• Automatically during recording
Track numbers are automatically marked as on the
original source during recording from this
system's CD player. Use the Level Synchro
Recording function to automatically mark track
numbers during recording from this system's tuner
or components connected to the TAPE
CONTROL jack or the TAPE IN jacks. However,
you cannot mark track numbers automatically if
the sound source to be recorded is noisy (e.g.,
tapes or radio programmes) or during timer-
recording.
• At any point during recording
You can mark track numbers during recording any
sources.
• After recording
Use the Divide function (see page 41).
Marking track numbers
automatically during
recording
— Level-Synchro Recording
The Level Synchro Recording function is factory
set to on, so the track numbers are automatically
marked. If "L.SYNC" does not appear during
recording, turn on the Level Synchro Recording as
follows. Track numbers are automatically marked
when the input signal is continuously below a
certain level for more than two seconds and then
exceeds that level.
1
3,4,5
2,6
1
Press MD to switch the function to MD.
2
Press MENU/NO in stop mode.
3
Press . or > repeatedly until
"Setup ?" appears, then press ENTER/
YES.
4
Press . or > repeatedly until
"T.Mark Off" (or "T.Mark LSync")
appears, then press ENTER/YES.
5
Press . or > repeatedly until
"T.Mark LSync" appears, then press
ENTER/YES.
"L.SYNC" lights up.
6
Press MENU/NO.
To continue and record, follow the
procedures described on the various
recording pages.
To cancel automatic track
marking
Press . or > repeatedly until "T.Mark Off"
appears in step 5, then press ENTER/YES.
"L.SYNC" disappears. When "L.SYNC" is off, a
track number is marked only at the beginning of
each recording.
3,4,5
3,4,5
continued
29