To Stop Recording - Sony DHC-MD373 Operating Instructions Manual

4
Press TUNING + or – to select the
desired preset station.
Preset number and frequency (or station
name* or RDS station name**)
* The station name appears only if you have
labelled the station (see page 46).
** European model only.
When you preset only one station, "ONE
PRESET" appears in the display.
You can select the preset numbers with the
numeric buttons on the remote.
5
Press z REC.
The MD deck stands by for recording and the
z REC button lights red.
6
Press MD HS.
Recording starts.

To stop recording

Press MD x.
Before inserting an MD
When the system is on, make sure the MD
indicator is off. If the MD indicator is lit red,
another MD is already inserted. Press MD Z and
remove the MD.
Tips
• If noise is heard while recording an AM radio
programme, move the AM loop aerial to reduce the
noise or connect a ground wire to the U terminal
(see page 53).
• If you select "MONO" in step 3, the MD is
recorded in monaural format. For details, see
"Monaural recording" on page 34.
• You can adjust the recording level to the desired
volume after performing step 5 (see page 33).
Before pulling out the mains lead
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the system. Do not pull out the mains lead
before updating the TOC (while "TOC" is lit) or
while updating the TOC (while "TOC" is flashing)
to ensure a complete recording.
Note
If the MD is record protected, "C11" and "Protected"
appear alternately and the MD cannot be recorded.
Remove the MD, then slide the record protection tab
to the closed position (see page 25).
15