Marking Track Numbers - Sony DHC-NX5MD Operating Instructions Manual

Marking track numbers

You can mark track numbers:
• Automatically during recording
Track numbers are automatically marked as on the
original source during recording from this
system's CD player. However, track numbers may
not be marked for some tracks (see page 71). Use
the Level Synchro Recording function to
automatically mark track numbers during
recording from this system's tuner or components
connected to the VIDEO jacks or the TAPE IN
jacks. However, you cannot mark track numbers
automatically if the sound source to be recorded is
noisy (e.g., tapes or radio programmes) or during
timer-recording.
• At any point during recording
You can mark track numbers during recording any
sources.
• After recording
Use the Divide Function (see page 48).
Marking track numbers
automatically during
recording
The Level Synchro Recording function is factory
set to on, so the track numbers are automatically
marked. If "L-SYNC" does not appear during
recording, turn on the Level Synchro Recording as
follows. Track numbers are automatically marked
when the input signal is continuously below a
certain level for more than two seconds and then
exceeds that level.
Note
You can not mark track numbers automatically if the
sound source to be recorded is noisy (e.g., tapes or
radio programmes).
34
— Level-Synchro Recording
?/1 (Power)
MD s 2
1
Press one of the function buttons you
want to record (e.g., TUNER).
2
Press REC/REC IT to stand by for
recording.
3
Press MENU/NO.
"Setup?" appears, then press ENTER/YES.
1 3,4,5
1
2
3
4
5
7 3,6 4,5