Table of Contents
Advertisement
1
Insert a recordable MD.
2
Press FUNCTION repeatedly until the
desired source to record appears.
3
Press MD z REC.
The MD deck stands by for recording.
4
Start playing the desired source to
record.
5
Press TIME MACHINE REC at the
desired point to start recording.
Recording of the source starts with the 6
seconds of audio data stored in the buffer
memory.
If you use a partially recorded MD, recording
starts after the recorded tracks.
To stop Time Machine Recording
Press x.
Before pulling out the mains lead
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the system. Do not pull out the mains lead
before updating the TOC (while "TOC" is lit) or
while updating the TOC (while "TOC" is flashing)
to ensure a complete recording.
Note
The MD deck starts storing audio data when the deck
stands by for recording in step 3 and you start playing
the source. If less than 6 seconds have passed when
you press TIME MACHINE REC, Time Machine
Recording starts with less than 6 seconds of audio
data.
Marking track numbers
You can mark track numbers:
• Automatically during recording
Track numbers are automatically marked as on
the original source during recording from this
system's CD player or components connected
to the DIGITAL OPTICAL IN jack. However,
track numbers may not be marked for some
tracks (see page 65). Use the Level Synchro
Recording function to automatically mark track
numbers during recording from this system's
tuner or components connected to the
ANALOG IN jack or the TAPE IN jacks.
However, you may not mark track numbers
automatically if the sound source to be recorded
is noisy (e.g., tapes or radio programmes).
• At any point during recording
You can mark track numbers during recording
any sources.
• After recording
Use the Divide function (see page 47).
Marking track numbers
automatically during
recording
— Level-Synchro Recording
The Level Synchro Recording function is factory
set to on, so the track numbers are automatically
marked. If "L-SYNC" does not appear during
recording, turn on the Level Synchro Recording as
follows. Track numbers are automatically marked
when the input signal is continuously below a
certain level for more than two seconds and then
exceeds that level.
continued
35
Advertisement
Table of Contents
