Access Point - Canon PIXMA IP4000R Setup Manual

22
12
Setup automatically detects your

access point.

If you connect to a network that is not protected with
security measures, there is a risk of disclosing data
such as your personal information to a third party.
An access point is detected automatically and setup
proceeds to the next step when
• Setup detects an access point with the same SSID
as the access point currently connected to your
computer, and the access point is not using
encryption.
• Setup did not detect an access point with the same
SSID as the access point currently connected to
your computer (or your computer is currently not
connected to an access point in the first place), but
a single access point without encryption was
detected.
If the detected access point is using encryption
When setup detects an access point with the same SSID
as the access point currently connected to your computer,
and the access point is using encryption (WEP or WPA),
the Access Points dialog box is displayed with the
access point highlighted in the list.
Enter the network key (WEP key or WPA key) set to the
access point and click Connect.
If multiple access points were detected
If setup did not detect an access point with the same
SSID as the access point currently connected to your
computer (or your computer is currently not connected to
an access point in the first place), and two or more access
points were detected, the Access Points dialog box is
displayed.
Select your target access point and click Connect.
If WEP or WPA is displayed in the Encryption column,
a network key (WEP or WPA key) is set to your access
point. Enter the network key (WEP key or WPA key) set
to the access point and click Connect.
You cannot connect to an access point using WPA-
802.1x or an access point using WPA-PSK with type of
dynamic encryption set to AES. See "The Access
Points dialog box is displayed during setup" on
page 72.