Confirming Settings Of Your Access Point - Canon PIXMA IP4000R Setup Manual

Confirming Settings of your Access Point

When setting up the printer to be used over wireless LAN, the printer's network settings are
configured to match those of the access point. Therefore, if you are using wireless LAN, we
recommend that you confirm the necessary information on the access point before entering the
setup process. Check and fill in the table below.
SSID/network name
Stealth/closed network
ANY-Rejection
Radio channel
Encryption
MAC address filtering
IP address filtering
Client-to-Client Blocking
For information on how to confirm the settings of the access point, refer to the manual provided with the
access point.
• If Stealth (closed network) or ANY-Rejection feature is enabled
We recommend you to disable it before entering setup.
• If MAC address filtering is enabled
We recommend that you register the printer's MAC address to the access point before entering setup. To
confirm the MAC address of the printer, print the printer's network information. See "Printing Network
Setting Information" on page 67.
• If IP address filtering is enabled
Disable the access point's IP address filtering feature before entering setup.
• If Client-to-Client Blocking is enabled
An access point may be capable of blocking all direct transmission among clients associated to it. If such
feature is enabled, disable this feature before entering setup.
18
Disabled
Disabled
Channel ( )
The printer can communicate in channels 1 to 11.
Disabled
Disabled
Disabled
Disabled
Enabled
Enabled
Enabled
WEP: key (
WPA: key (
This printer supports only the PSK-TKIP
authentication type.
Enabled
Enabled
Enabled
)
)