Chapter 3
Installing the Software and Initially Configuring a CDE
Figure 3-22
Step 4
Verify that the devices you configured for your CDS network are listed.
If a device is not listed, restart the CMS for that device by using either the console or Telnet connection
Step 5
and entering the following commands from the global configuration mode:
CDE(config)# no cms enable
CDE(config)# cms enable
The installation is now complete. Refer to the Cisco Internet Streamer CDS 2.0 Software Configuration
Guide for information on configuring and using the CDS. See the
page vi
OL-13478-01
Devices Page
"Related Documentation" section on
Cisco Content Delivery Engine Hardware Installation Guide
Verifying the CDSM
3-17