Advertisement
Before You Begin
For the CDE-200, do not use the internal CD-ROM drive for recovery or remanufacture procedures. Use
Note
the external USB CD-ROM drive for all procedures that require a CD-ROM.
For the CDE-100, use the internal CD-ROM drive for recovery or remanufacture procedures.
Note
You also need to configure the ports on the CDE-200 as shown below:
The two built-in Gigabit Ethernet ports are GigabitEthernet 1/0 and GigabitEthernet 2/0 and are
•
management ports using channel bonding 1 (see numbers 6 and 7 in
–
–
The four interface ports on the stream interfaces are GigabitEthernet 3/0, GigabitEthernet 4/0,
•
GigabitEthernet 5/0 and GigabitEthernet 6/0 using channel bonding 2 (see number 8 in
–
–
–
–
Figure 3-1
1
Power connectors
2
Mouse connector
3
Keyboard connector
4
Serial console interface
In some CDE-200 chassis the streaming interface NICs are installed in slots 4 and 5 (counting from the
Caution
left-most slot). In this hardware configuration, the Gigabit Ethernet interfaces on the motherboard are
detected as interfaces 3/0 and 4/0, and the interfaces on the NICs are detected as 1/0, 2/0, 5/0, and 6/0.
The interface numbering must be taken into consideration when configuring IP addresses and
port-channels.
Cisco Content Delivery Engine Hardware Installation Guide
3-2
eth0 -> g1/0
eth1 -> g2/0
eth2 -> g3/0
eth3 -> g4/0
eth4 -> g5/0
eth5 -> g6/0
Interface Port Locations
Chapter 3
Installing the Software and Initially Configuring a CDE
Figure
5
VGA interface
6
GigabitEthernet 1/0
7
GigabitEthernet 2/0
8
Stream interfaces (G3/0, G4/0, G5/0, G6/0)
3-1).
Figure
3-1).
OL-13478-01
Advertisement
