Advertisement
Chapter 3
Installing the Software and Initially Configuring a CDE
Enter the following commands to run the Setup utility:
Step 1
CDE# setup
CDE#
What is the mode of the device (SE/SR/CDSM) [SE]: SE
Is this SE going to be managed by a CDSM (Content Delivery System Manager) (y/n) [y]:y
Please choose an interface to configure from the following list:
1: GigabitEthernet 1/0
2: GigabitEthernet 2/0
3: GigabitEthernet 3/0
4: GigabitEthernet 4/0
5: GigabitEthernet 5/0
6: GigabitEthernet 6/0
Enter choice: 1
Do you want to enable DHCP on this interface (y/n) [n]: n
Please enter the IP address of this interface: 209.165.200.255
Please enter the netmask of this interface: 255.255.255.244
Please enter the default gateway: 10.0.0.0
Please enter the domain name server ip: 172.16.0.0
Please enter the domain name: spcdn.com
Please enter the hostname: CDStr1
Please enter CDSM (Content Delivery System Manager) IP or Host name: 209.165.201.0
Press any key to continue
CDE# configure terminal
CDE# cms enable
This initiates database services on the device that you just configured.
Once the IP default gateway has been set, we recommend you ping the outside network to verify it is
Note
reachable. Then verify that the CDSM is reachable.
After you have run the Setup utility on each SE SR, they register with the CDSM. Save the configuration
by entering the following command:
CDE# copy running-config startup-config
Verifying the CDSM
Perform the following steps to verify that the CDSM is operational:
Step 1
Launch a web browser and enter the CDSM IP address. The CDSM Login page appears (see
Figure
Enter admin as the username and default as the password and press Login.
Step 2
OL-13478-01
3-20).
Cisco Content Delivery Engine Hardware Installation Guide
Verifying the CDSM
3-15
Advertisement
