Advertisement
Running the BIOS Setup Utility
Use the arrow keys to return to the Advanced menu. Choose Console Redirection and press Enter. The
Step 11
Console Redirection screen appears (see
Figure 3-18
Set the Com Port Address option to On-board COM A.
a.
Set the Baud Rate option to 9600.
b.
Set the Continue C.R. after POST: option to On.
c.
When you are finished, navigate to the Exit submenu and choose Exit Saving Changes. Press Yes when
Step 12
prompted (see
Figure 3-19
Ensure that the CD with the CDS software image is in the USB CD drive and press Enter to confirm and
Step 13
reboot the system. Your configuration is saved, you exit the BIOS Setup menu, and the system reboots.
Sometimes the USB CD-ROM drive is not picked up by the BIOS after the first power-on. In this
a.
case, the CD-ROM drive is not present in the above Hard Drive element list. Press the Reset button
(not the Power button) and try again. If it still fails, try a different USB CD-ROM drive.
Cisco Content Delivery Engine Hardware Installation Guide
3-12
Console Redirection Screen
Figure
3-19).
Exit Saving Changes Screen
Chapter 3
Installing the Software and Initially Configuring a CDE
Figure
3-18).
OL-13478-01
Advertisement
