Advertisement
Chapter 3
Installing the Software and Initially Configuring a CDE
Set the P-ATA Channel Selection option to Both.
c.
Note
Press Esc to return to the Advanced menu. Choose Super I/O Configuration and press Enter. The
Step 12
Configure Super I/O Chipset screen appears (see
Figure 3-10
Set the Serial Port2 Address option to Disabled.
Step 13
Press Esc to return to the Advanced menu. Choose Remote Access Configuration and press Enter. The
Configure Remote Access Type and Parameters screen appears (see
Figure 3-11
Set the Serial port number option to COM 1.
a.
Set the Serial Port Mode option to 9600 8, n, 1.
b.
c.
Set the Redirection after BIOS POST option to Disabled.
Step 14
When you are finished, navigate to the Exit submenu and choose Save Changes and Exit. Press OK
when prompted (see
OL-13478-01
On the CDE-100, the Primary IDE Slave is connected to the internal CD-ROM, the Secondary
IDE Master is connected to 128 MB compact flash.
Configure Super I/O Chipset Screen
Configure Remote Access Type and Parameters screen
Figure
3-12).
Figure
3-10).
Figure
Cisco Content Delivery Engine Hardware Installation Guide
Running the BIOS Setup Utility
3-11).
3-7
Advertisement
