Advertisement
Chapter 3
Installing the Software and Initially Configuring a CDE
Installation and Configuration Order
Perform the initial installation and configuration of your CDS network in the following order:
1.
2.
3.
Caution
It is very important that the onboard SCSI controller be disabled on the CDE-200. Do this by physically
opening the CDE-200 case (by removing two side screws and a back thumbscrew), and verifying that the
jumper labeled "JPA-1" (located about two inches below the center PCI-X slot—slot 3 of 5) has pins 2
and 3 connected (instead of 1 and 2). Pin 1 is closest to the rear of the case and pin 3 is closest to the front.
Running the BIOS Setup Utility
Running the BIOS setup utility is different for the CDE-100 and the CDE-200; therefore, this section
provides a separate BIOS setup procedure for each CDE.
Running the BIOS Setup Utility for the CDE-100
Perform the following steps to run the BIOS setup utility for the CDE-100:
Power on the CDE-100.
Step 1
Insert the CD with the CDS image into the internal CD-ROM drive (see
Step 2
Figure 3-2
Reboot the CDE-100 and wait for the initial BIOS screen to appear.
Step 3
Note
Step 4
changed for the second and subsequent installations or recovery.
To enter the BIOS Setup menu, press Delete as instructed at the bottom of the BIOS screen. The Main
Step 4
menu appears (see
OL-13478-01
Run the BIOS setup utility on each CDE in the CDS network.
Install the CDS release 2.0 software on each CDE in the CDS network.
Configure the CDSM.
CDE-100 Front View
through
Step 15
are required only for the initial installation. The BIOS setup does not need to be
Figure
3-3).
Cisco Content Delivery Engine Hardware Installation Guide
Running the BIOS Setup Utility
Figure
3-2).
3-3
Advertisement
