Advertisement
Chapter 3
Installing the Software and Initially Configuring a CDE
Running the BIOS Setup Utility for the CDE-200
Perform the following steps to run the BIOS setup utility for the CDE-200:
Ensure that the CDE-200 is powered off.
Step 1
Attach the USB CD-ROM drive to any available USB port at the rear of the CDE-200 (see
Step 2
Power on the USB CD-ROM drive.
Step 3
Power on the CDE-200 and wait for the initial BIOS screen to appear.
Step 4
Note
Step 5
changed for the second and subsequent installations or recovery.
To enter the BIOS Setup menu, press Delete as instructed at the bottom of the BIOS screen. The Main
Step 5
menu appears (see
Figure 3-13
Tip
Ctrl-Backspace functions the same as the Delete key if you are viewing the initial BIOS screen through
a remote terminal server.
Use the arrow keys to navigate to the Advanced menu and press Enter. The Advanced menu appears (see
Step 6
Figure
OL-13478-01
through
Step 12
are required only for the initial installation. The BIOS setup does not need to be
Figure
3-13).
Main Menu
3-14).
Cisco Content Delivery Engine Hardware Installation Guide
Running the BIOS Setup Utility
Figure
3-1).
3-9
Advertisement
