Advertisement
D6 裝置的調整
警告
進行調整作業時，請關閉電源開關，請專業技
術人員操作。
另外，進行作業時，注意避免裁料刀具割傷手
指。
1. 高度調整
押具保持抬起狀態時，鬆動螺絲 SM532 可
上下調整，使押具與 D6 裝置切刀面的間隙
1.0~2.0mm。
2. 調整送料滾軸的左右方向
(1) 鬆動螺絲 SM441 和內六角螺絲 SM514。
(2) 保持彈簧板 FD621 不移動，左右調整內
六角螺絲 SM514 始送料滾軸與布料行進
方向呈直角狀態。
(3) 鎖緊內六角螺絲 SM514 和螺絲 SM441。
SM441
FD621
D6 DEVICE ADJUSTMENTS
Please turn off the power switch during
adjustment and the adjustment operations
must be carried out by professional technical
personnel. In addition, please prevent the cutting
tools from cutting your fingers during adjustment.
1. Height Adjustment
Keep the presser foot in lifted position.
The loose screw Sm532 can be adjusted up
and down, and keep the gap of presser foot
and D6cutter device within 1.0~2.0mm.
SM532
2.Adjust the left and right direction of the feed
roller
(1)loose screw Sm441 and hexagon socket
head cap screw SM514.(FIG.6)
(2)keep spring plate FD621 fixed, adjust the
hex socket head cap screw SM514 in left
or right direction to make feed roller and
fabric forward motion as right angles.
(3)fasten hexagon socket head cap screw
SM514 and screw SM441.
Introduction
SM514
P14
Advertisement
