Wait Timeout; Troubleshooting A Group Configuration - 3Com 3C990B-TX-M User Manual

6 Installing NetWare Drivers
72

wait timeout

This command sets the timeout value, in seconds, that the software waits before marking
a NIC that is in wait mode as failed (see retry count). If no argument is specified or if the
specified argument is invalid, the current value is displayed. Otherwise, the new value is
displayed.
Syntax lbrsl wait timeout seconds
where:
seconds is any positive integer.
Example
lbrsl wait timeout 2
Default 1
Troubleshooting a Group Configuration
Use the troubleshooting tip in the table below to solve problems that may occur in a
group configuration.
NOTE: To access a database of technical information that can help you diagnose
and solve NIC installation, configuration, and upgrade problems, go to:
http://knowledgebase.3com.com
Symptom
More than one non-3Com server NIC
has been detected in one or more
groups on this server.
Tip
You can use only one NIC that is not a 3Com server NIC in
one 3Com load balancing/RSL group per server. Check the
groups and remove all but one of the non-3Com server
NICs from the groups.