Adding A Group - 3Com 3C990B-TX-M User Manual

load se
load lbrsl
;Define primary NIC slot-frame instances
load 3c99x slot=10001 frame=ethernet_802.2 name=p1_802.2
load 3c99x slot=10001 frame=ethernet_ii
;Define secondary NIC slot-frame instances
load 3c99x slot=10002 frame=ethernet_802.2 name=p2_802.2
load 3c99x slot=10002 frame=ethernet_ii
load 3c99x slot=10003 frame=ethernet_802.2 name=p3_802.2
load 3c99x slot=10003 frame=ethernet_ii
;Bind protocols to primary NIC
bind ipx to p1_802.2 net=FF02
bind ip to p1_ii
;Create a group with NIC 10001 primary and NICs 10002 and
1003 secondary
lbrsl group lb 10001 10002 10003
;To create a resilient server link group without load
balancing (for
;use with NICs from manufacturers other than 3Com) use the
rsl option:
;lbrsl group rsl 10001 10002 10003

Adding a Group

To add a load balancing group, follow these steps:
1 Install the NICs.
Follow the procedures in "Installing and Connecting the NIC" on page 18.
Connect all NICs in the group to the same network.
2 Make the following changes to the AUTOEXEC.NCF file:
Add or verify the LOAD commands for the LAN drivers for all slot-frame instances.
I
In each group, load the same protocols and frame types on the primary and all
I
secondary NICs.
On the primary NIC only, bind a protocol to each slot-frame instance.
I
Remove any BIND commands from each secondary NIC.
I
For each group, add an LBRSL GROUP command to bind the primary and secondary
I
NICs together. There can be only one LBRSL GROUP command per group, and it
must list the primary and all secondary NICs. Place this command after the LAN
driver LOAD commands or the SYS:ETC\INITSYS.NCF command. To specify a load
balancing group with resilient server links, use the LB option. To specify a resilient
server link group without load balancing, use the RSL option.
For the LBRSL GROUP command syntax, see "Server Feature Commands" on
page 69.
address=192.1.1.1 mask=ff.ff.ff.00
Maintaining Groups
name=p1_ii
name=p2_ii
name=p3_ii
67