Installing Server Features; Configuring Groups - 3Com 3C990B-TX-M User Manual

6 Installing NetWare Drivers
62
3 NetWare lists the valid slot number(s) for the NIC, depending on how many NICs are
installed. The values appearing in the list are the slot values that you should use.
Example:
After you issue the command, a message appears. At the end of the message,
additional text similar to the following appears:
Total of 2 3C99x PCI adapter card(s) found. Supported slot
values are 2,3.
Slot:2

Installing Server Features

Two drivers are associated with 3Com Advanced Server technology features under
NetWare: SE and LBRSL.
1 From the Configuration Options screen select Product options.
2 Select Install a product not listed.
The following message appears:
Product will be installed from A:\. If you are installing
from floppy, insert the first diskette of the product you
want to install into the drive and verify that the path above
is correct.
Press <F3> to specify a different path;
Press <ENTER> to continue.
3 Press F3.
4 Enter this command:
3c99xC_txm:\nwserver
The following message appears:
Product "3Com DynamicAccess Server Features" was found.
Verify that this is the product you want to install before
proceeding.
Press <ENTER> to continue.
Press <ESC> to abort installation.
5 Press Enter.
The system copies the 3Com Advanced Server software to the SYS volume.
Configuring Groups
1 Press Esc to return to the Installation Options screen.
2 From the Configuration Options screen, select NCF files options (create/edit server
startup files)
3 Select Edit AUTOEXEC.NCF file.
4 Make the following changes to the AUTOEXEC.NCF file:
a Add a command to load the SE and LBRSL drivers before any commands to load
LAN drivers. For example:
load se
load lbrsl