Table of Contents
Advertisement
Introduction
1.3 Required Tools and Materials
Power Module Indicator LEDs
RS-232 Console Port
1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM RS416F:
AC power cord (16 AWG)
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
1.4
Decommissioning and Disposal
Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated Configuration Manual.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related
accessories, contact a facility certified to dispose of waste electrical and electronic
equipment. Recycling and disposal must be done in accordance with local
regulations.
4
The power module indicator LEDs indicate the status of the power
modules.
Green
Red
Off
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device (Page
Tools/Materials
Color
The power supply is supplying power
Power supply failure
No power supply is installed
21)".
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Installation Manual, 04/2021, C79000-G8976-1354-04
Description
Purpose
RUGGEDCOM RS416F
Advertisement
Table of Contents
