Important Safety Information - Wallbeds Australia AB-4 Assembly Instructions Manual

Start the Bookcase assembly by using either one of the Bookcase End Panels and fixing it to the

Back Panel. Ensure the cam locks on the Back Panel are not facing what will be the inside of the

Back Panel - Place the Bookcase Back Panel onto the End Panel. Match up the cam locks with the

cam pins. Tighten the cam locks and cam pins together by using a Phillips head hand

screwdriver.

Top & Bottom Panels - With the cam locks facing away from the inside of the Bookcase attach

the Bottom Panel to the End Panel and Back Panel. Repeat this process with the Top Panel.

Place the remaining End Panel on top of the previously assembled panels. Ensuring the cam pins

are lined up with the cam locks. Tighten the cam pins to the cam locks.

Tip: You may need to lightly tap the cam pins into the cam locks with a rubber mallet. Ensure you

do this where the cam pins are. Failure to do so may result in damage to the End Panel.

Step 3 – Fixing both Units together and to the Alpha Wall Bed

• Place the Drawer Cabinet unit next to the side of the Alpha Wallbed that it will be attached to.

Ensure the front edge of the drawers are flush with the front edge of the wall bed cabinet.

• Place the bookshelf unit on top of the drawer cabinet unit and line up the front of the bookcase

bottom panel with the front edge of the drawer.

• Check that the bookshelf end panel is also flush with the front edge of the wall bed cabinet end

panel.

When attaching the Pull Out Drawer / Table unit to the bookshelf.

• Remove the pull out drawer / & pre-drill a 5mm hole up through the top panel of the pullout

drawer unit into the bottom panel of the bookshelf. Do one towards the front and then one

towards the back of the unit. IMPORTANT - Use caution not to go all the way through to the

bottom panel of the bookcase. Attach together using the 28mm screws supplied.

• Using an existing shelf pin hole, fix the bookshelf to the side of the bed cabinet by using the

28mm wood screws supplied.

To remove once installed, heat up with hair dryer & then to remove any sticky residue

Avoid using a razor blade as you may damage the cabinetry.

All WallBeds Australia Bookcases and Cabinets must be securely attached

to the WallBed before use. Ensure that children DO NOT climb or hang on

Step 2 - Bookcase Assembly

Bookcase when built.

You will need to pre-drill the 5mm screw holes.

Removing Panel Stickers/Labels

use wax and grease remover or similar.

IMPORTANT SAFETY INFORMATION

any part of the Bookcase or Cabinet.

Failure to do so may result in personal injury.