Advertisement
Note: If you have two of the same cabinet each cabinet will have a different cabinet number.
Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the
units have been built, as these will assist with assembly. Most of the stickers are placed
on the "back" or underside of the cabinet and will not be seen once assembled.
Top & Bottom Panel
Kick Panel
©2019 WallBeds Australia
AB-1 Bookcase Assembly Instructions
AB-1 Bookcase Cabinetry Panels
End Panel
Back Panel
End Panel
1
Advertisement
Table of Contents
Related Manuals for Wallbeds Australia AB-1
Summary of Contents for Wallbeds Australia AB-1
- Page 1 AB-1 Bookcase Assembly Instructions Note: If you have two of the same cabinet each cabinet will have a different cabinet number. Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the units have been built, as these will assist with assembly. Most of the stickers are placed on the “back”...
- Page 2 AB-1 Hardware Parts Cam Lock Cam Pin Shelf Pin 28mm Wood Screw Step 1 – Inserting Hardware Cam Locks – Insert all Cam Locks into the following panels as described by the cabinet part located on the cabinet sticker. Rail...
- Page 3 IMPORTANT SAFETY INFORMATION All WallBeds Australia Bookcases and Cabinets must be securely attached to the WallBed before use. Ensure that children DO NOT climb or hang on any part of the Bookcase Or Cabinet. Failure to do so may result in personal injury.
- Page 4 Image 1 Removing Panel Stickers/Labels Remove once installed, heat up with hair dryer & then to remove any sticky residue use wax and grease remover or similar. Avoid using a razor blade as you may damage the cabinetry. ©2019 WallBeds Australia...
Need help?
Do you have a question about the AB-1 and is the answer not in the manual?
Questions and answers