Wallbeds Australia AB-4b Assembly Instructions Manual

Hide thumbs

page of 12

/ 12
Bookmarks

Quick Links

Download this manual

• Please read and understand the instructions prior to assembly.

Incorrect installation of this product could possibly result in

personal injury or physical damage.

• WallBeds Australia recommends two people to safely assemble

and install the wall bed - It is not recommended you try to install

this bed on your own.

• The wall bed MUST be securely fastened to the wall prior to use.

Failure to do so will cause the bed to tip over & may cause

damage to the cabinet or serious personal injury.

• All additional cabinetry must be securely fasten to the Wall Bed

cabinet.

• Whilst these products are DIY it is recommended the wall bed be

installed by a qualified trades person if you are not comfortable

with the installation of this product.

WallBeds Australia is not responsible for any damages

Important Safety Advice Sheet

PLEASE READ BEFORE YOU BEGIN:

or injuries incurred by incorrect installation of this

product.

Summary of Contents for Wallbeds Australia AB-4b

Page 1 Incorrect installation of this product could possibly result in personal injury or physical damage. • WallBeds Australia recommends two people to safely assemble and install the wall bed - It is not recommended you try to install this bed on your own.
Page 2 Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the units have been built, as these will assist with assembly. Most of the stickers are placed on the “back” or underside of the cabinet and will not be seen once assembled. AB-4b Drawer Cabinetry Panels End Left Top Panel...
Page 3 AB-4b Drawer Hardware Parts Pull Out Drawer / Table Runners Small Handle Drawer Clip Drawer Runners & Handle Fixing Screw Cam Pin Metal Drawer Sides Cam Lock Done Head Screw Euro Screw 28mm Wood Screw Step 1 – Inserting Drawer Cabinetry Hardware Cam Locks –...
Page 4 Insert these into the drawer front ensuring the up & down arrows on the drawer clips are facing the outside edge of the drawer panel. Fix these into the drawer front by tapping them in gently with a hammer - Refer image 11 page 11 ©2019 WallBeds Australia...
Page 5 Once the drawer front is the correct way up, push the drawer front into the metal sides of the drawer until you hear the drawer click into place on both sides. Tighten the screws on the outside of the drawer clips using a Phillips head hand screwdriver. ©2019 WallBeds Australia...
Page 6 AB-4b Bookcase Instructions Note: If you have two of the same cabinet each cabinet will have a different cabinet number. Prior to assembly, separate and group all matching panels panel numbers. Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the units have been built, as these will assist with assembly.
Page 7 Cam Pins Insert all Cam Locks into the following panels as described by the cabinet part located on the cabinet sticker. Bottom NOTE: In the Top and Bottom Panels Insert the cam pins on the opposite side to the Cam Lock. ©2019 WallBeds Australia...
Page 8: Important Safety Information
Avoid using a razor blade as you may damage the cabinetry. IMPORTANT SAFETY INFORMATION All WallBeds Australia Bookcases and Cabinets must be securely attached to the WallBed before use. Ensure that children DO NOT climb or hang on any part of the Bookcase or Cabinet.

Wallbeds Australia AB-4b Assembly Instructions Manual

Quick Links

Related Manuals for Wallbeds Australia AB-4b

Summary of Contents for Wallbeds Australia AB-4b

Page 8: Important Safety Information