Advertisement
To attach the cabinet to the wall bed you will need to pre-drill four 5mm pilot holes. These holes
IMPORTANT - When pre-drilling the wood screw pilot holes use caution not to go all the way
through to the end panel of the wall bed.
• Temporarily fasten the cabinets together with clamps. Pre-drill a total of four 5mm pilot
holes in the end panel of the cabinet — two towards the top of the unit and two at the
bottom. Attach the cabinet to the wall bed using the 28mm screws supplied. Then remove
the clamps.
Caution: Do Not over tighten the wood screws into the side of the cabinet End Panel as it may
Attaching Door Handle -
Place the handle over the pre-drilled holes in the door panel. Insert the handle screws through
the pre-drilled holes in the door panel and tighten using a Phillips head screwdriver.
All WallBeds Australia Bookcases and Cabinets must be securely attached
to the WallBed before use. Ensure that children DO NOT climb or hang on any part
To remove once installed, heat up with hair dryer & then to remove any sticky residue
use wax and grease remover or similar.
Avoid using a razor blade as you may damage the cabinetry.
©2019 WallBeds Australia
Step 4 Attaching the Cabinet to your wall bed
will be covered using the FastCaps supplied.
end up protruding through the opposite side of the panel.
IMPORTANT SAFETY INFORMATION
of the Bookcase or Cabinet.
Failure to do so may result in personal injury.
Removing Panel Stickers/Labels
4
Advertisement
