Advertisement
Start the cabinet assembly by using either one of the End Panels.
Back Panel - With the cam locks are facing away from the inside. Place the cabinet back
panel onto the side panel. Match up the cam locks with the cam pins. Tighten the cam
locks and cam pins together by using a Phillips head hand screwdriver.
Bottom panel - With the cam locks facing away from the inside of the cabinet attach the
bottom panel to the end panel and back panel. Refer to images 6 & 7 page 10
Top Panel - With the cam locks facing the inside of the cabinet attach the bottom panel to
the end panel and back panel. - Ensure the cam locks are facing the inside of the cabinet.
Kick/Rail - With the cam locks facing to the back of the cabinet attach the kick panel
to the end panel.
Place the remaining end panel on top of the previously assembled panels. Ensuring the cam
pins are lined up with the cam locks. Tighten the cam pins to the cam locks.
Note – There are no guide holes on the underside of the drawer bottom panel for the metal
drawer sides. The dome head screws supplied do not require these holes to be pre-drilled.
With the cam locks facing the back attach the drawer back to the drawer bottom panel.
Tighten cam locks to cam pins. Refer to image 4 page 9
Metal Drawer Sides - Using the dome head screws fix the metal drawer sides to the drawer
bottom and drawer back panels . Refer to images 3 & 4 page 9 . Place assembled drawer
into the drawer unit. -
DO NOT ATTACH DRAWER FRONTS UNLESS THE DRAWERS ARE IN THE CABINET.
To ensure you place the drawer front up the correct way Refer to images 8 and 9 on page 10
Do not fully connect the drawer front onto the metal drawer sides until you are sure the drawer
front is up the correct way.
Attaching the Drawer Front - Starting with the top drawer, gently close the drawer ensuring
the top edge of the drawer front is level with the top panel of the drawer unit.
If the drawer front is higher than the top panel, remove it from the drawer clips and turn the
drawer front up the opposite way.
Double-check the drawer front is now level with the cabinet top panel.
Once the drawer front is the correct way up, push the drawer front into the metal sides of the
drawer until you hear the drawer click into place on both sides. Tighten the screws on the
outside of the drawer clips using a Phillips head hand screwdriver. Refer to images 10 & 11 on
page 11
©2020 WallBeds Australia V4
Step 2 Ab-4 Drawer Unit Assembly
Drawer Assembly
5
Advertisement
