Wallbeds Australia AB-2a Assembly Instructions

Cabinet

Download this manual

AB-2a- Cabinet Assembly Instructions

Note: If you have two of the same cabinet each cabinet will have a different cabinet number.

Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the

units have been built, as these will assist with assembly. Most of the stickers are placed

on the "back" or underside of the cabinet and will not be seen once assembled.

AB-2a Cabinetry Panels

End Panel

Top Panel

Door Panel

Back Panel

End Panel

Bottom Panel

Fixed Shelf

Kick Panel

Page 1 AB-2a- Cabinet Assembly Instructions Note: If you have two of the same cabinet each cabinet will have a different cabinet number. Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the units have been built, as these will assist with assembly. Most of the stickers are placed on the “back”...
Page 2 AB-2a Hardware Parts Cam Lock Small Handle Cam Pin Handle Fixing Screw Door Hinge Clip Door Hinge Step 1 – Inserting Cabinetry Hardware Cam Locks – Insert all Cam Locks into the following panels as described by the cabinet part located on the cabinet sticker.
Page 3 Once inserted press the back of the hinge arm until you hear it click into place. Refer to image 7 page 5 • Once the door is attached, check that the cabinet door panel is flush with the front edge of the end panel of the wall bed. ©2019 WallBeds Australia...
Page 4: Important Safety Information
Phillips head screwdriver. IMPORTANT SAFETY INFORMATION All WallBeds Australia Bookcases and Cabinets must be securely attached to the WallBed before use. Ensure that children DO NOT climb or hang on any part of the Bookcase or Cabinet.