Related Manuals for Wallbeds Australia Studio Alpha WallBed
Summary of Contents for Wallbeds Australia Studio Alpha WallBed
- Page 1 Assembly Instructions Alpha WallBed Studio Desk ** LIFETIME WARRANTY ** Designed to Exceed International ISO 9002 Standards for Residential Specifications - Patent Pending - Issue:041414 Let’s build a Wallbed together! ©2023 WallBeds Australia V1.9...
- Page 2 THE WALLBED END PANEL See Images 1 & 4 on page 5 (10pc) #8x40mm Wood Screws (30pcs) 19mm Self tapping Screw Pivot Brackets attach to wall bed End/Side Panels. The Desk/Table panels to the Upper Brackets ©2023 WallBeds Australia V1.9...
- Page 3 The Wallbed. L/H Side When You Are Leg Packer Facing The Wallbed. (Left and Right) Pivot Bracket (Left and Right) Legs to Pivot Brackets (2pc) M6x40mm Bolt (4pcs) Black Steel Washer Ø7.0xØ16.0mm (2pcs) M6 Nylock Nut ©2023 WallBeds Australia V1.9...
- Page 4 • Attach the Desk Packers to the wall bed End Panels. Ensuring the head of the wood screw is flush or lower than the surface of the Desk Packer. Once fully assembled these leg packers will square up the studio desk legs with the cabinetry. Image 3 Image 2 Image 4 ©2023 WallBeds Australia V1.9...
- Page 5 • Fix the Desk Top Brace to the underside of the Desk Top using the 28mm wood screws supplied. See the caution note below Caution Do not over tighten the 28mm wood screws into the Desk Brace Panel as it may result with the wood screw protruding through to the Desk Top. ©2023 WallBeds Australia V1.9...
- Page 6 Drawing #2: Fold Hinges to Desk Back Panel The short leaf attaches to the Back Panel. The long leaf will attach to the Bed Face Panel. Long Leaf Short Leaf Back Back Long Leaf Back Panel ©2023 WallBeds Australia V1.9...
- Page 7 Hand tighten the Bolts to join the Desk Top to the Legs. DO NOT over tighten as the Legs needs to be detached later to attach the Desk to the Bed Face. (Drawing #4). Drawing #4: Desk on floor (Side View) Cabinet Pivot Desk Top Bracket ©2023 WallBeds Australia V1.9...
- Page 8 • It is not necessary to remove Hinge Clips as they are out of sight after the installation. Pencil Mark Drawing #5: Hinge Clips top of Desk Back Long Hinge 38mm to the Leaf top of the Hinge Clip Clip Shelf Hinge Shelf Desk Back Clip Hinge Clip Shelf Hinge Clip Face ©2023 WallBeds Australia V1.9...
- Page 9 Image 5 STEP 5: Test Open WallBed to operate the Desk slowly. Double check the levels. Make sure that all End Caps are installed. ©2023 WallBeds Australia V1.9...