Page 1
AB1a- Cabinet Assembly Instructions Note: If you have two of the same cabinet each cabinet will have a different cabinet number. Panel Stickers/Labels –Do not remove any cabinet stickers from the panels until the units have been built, as these will assist with assembly. Most of the stickers are placed on the “back”...
Page 2
AB1a Hardware Parts Cam Lock Small Handle Cam Pin Shelf Pin Handle Fixing Screw Door Hinge Clip Door Hinge Step 1 – Inserting Cabinetry Hardware Cam Locks – Insert all Cam Locks into the following panels as described by the cabinet part located on the cabinet sticker.
Page 3
Door Hinge Clips – Attach the Hinge Plates before assembling the cabinetry. With the arrow indicator on the hinge block facing to the front edge of the panel. Line up the Hinge Plate with the pre-drilled holes in the End Panel. Fix these by tapping them in gently with a hammer, then tightening the screws.
Page 4
Attaching the Door to the Cabinet - Clip the hinge arm into the hinge block previously attached to the bookcase. Attaching the Cabinet to your wall bed - Check that the cabinet door panel is flush with the front edge of the wall bed End Panel. Using existing shelf pin holes (2 up towards the top and 2 at the bottom) attach the bookshelf to the side of the bed cabinet by using the 28mm wood screws supplied.