Procedure For Resetting The Camera; Disposal Of The Device (Environmental) - Oricom OBH36T User Manual

5. Procedure for Resetting the
Camera
Note:
If your Camera is moved from one router (e.g. home) to another (e.g.
office) or you have Camera setup issues, then the Camera must be reset.
Please reset the Camera with the following procedures:
• Disconnect from power, press and hold the PAIR button, plug in the
power connection and continue to hold the pair button for approximately
20 seconds, you will then hear a long beep, release PAIR button, wait for
the Camera Unit to complete an internal reset procedure. The Red LED
will begin to flash when the Camera Unit is reset successfully.
• You can add your Camera again by following the steps in section 4.4.4.

6. Disposal of the Device (environmental)

At the end of the product life cycle, you should not dispose of
this product with normal household waste. Take this product to
a collection point for the recycling of electrical and electronic
equipment. The symbol on the product, user's guide and/or
box indicates this.
Some of the product materials can be re-used if you take them to a recycling
point. By reusing some parts or raw materials from used products you make
an important contribution to the protection of the environment.
Please contact your local authorities in case you need more information on
the collection points in your area.
The internal battery should be disposed of with the Parent unit in an
environmentally-friendly manner according to your federal, state, and local
regulations.
24

Procedure for Resetting the Camera