Advertisement
STEP 4
You will need:
50 x nails (H3)
6 x Plastic Glides (H13)
P2
1
Ensure the unit is on it's front, raw edge up, Oak edge facing down
2
Join the 2 smaller back panels (P8) with the connect strip (P13) as shown
above then place over the larger opening. Place the larger back panel P9
over the remaining opening.
3
Make sure the unit is square by placing a back panel in corner and aligning
the edges of wardrobe.
4
Nail in each corner of back panels P8 and P9 and work along the unit,
making sure to hammer in the nails close to the edge so the nail penetrates
the unit.
5
Gently hammer in Plastic glides to bottom edges of wardrobe.
P9
P8
.
.
.
.
Page 7
Profile view of connector strip of backs P8
Top Of Strip P13
P8
Note: Top of strip (P13) to be facing
upwards when placing it on unit
P8
P3
White Edge down
P8
P13
Advertisement
