Table of Contents
Advertisement
Newer web browsers do support strong encryption on default.
5.2 Using PS/2 KVM over IP switch as a KVM switch
The power on state of 8/16 port PS/2 KVM over IP switch:
When you power on KVM switch, it will ask you the password, the default password value is
eight zero –" 00000000 ". Please key in eight zero and enter the same value at retype field.
Note: Before you are not familiar with the operation of OSD manual, please don't change the
password – i.e. keep default eight zero (00000000) value. Otherwise, if you have set the
password and unfortunately forget the password, you need send it back to your distributor for
maintaining the password.
The Membrane Buttons
8 port PS/2 IP-KVM Switch
The Push Buttons
Pressing the individual button to get PC port you want.
16 port PS/2 IP-KVM Switch
The Push Buttons
Pressing the individual button to get PC port you want. To press both "Shift " button and port
1(or port 2,3,4,5,6,7,8) individual button simultaneous to get PC port 9 (10,11,12,13,14,15,16)
respectively.
For example: The user would like to switch console port to PC port 12. He can press
"Shift" button and port 4 button simultaneously. The port LED of PC port 12 is lit when the
console is switched to PC port 12.
PC port LED Indication :
There are two LEDs--- Power LED (The LED is marked by " P ") and Link LED (The LED is
marked by " O " ) accompanied with each PC port.
When you select one of sixteen PC ports and this PC is shut down or this PC port is
disconnected to the PC, the selected power port LED is off (But, if this PC is PC99 type, the
selected power port LED is lit) and the Link LED is flash. When you select one of sixteen PCs
ports and this PC is powered on, the selected port Link LED and power LED is lit.
Note: If there are one of rack mount of KVM switches you used is 16 port IP-KVM switch,
Figure 5-1. The Internet Explorer displaying the encryption key length
~
1
8
1/9
8/16
~
~
:
:
20
8/16 PS/2 KVM over IP switch
Hide quick links:
Advertisement
Table of Contents
